Installation on mineral substrates
Monteringsanvisning

Installation on mineral substrates

Floor application for wedi building board

The substrate should be able to withstand the load and be cleaned of any mortar residue and dirt before you start to lay the wedi building boards. If necessary, treat the surface with primer. Eliminate unevenness. Newly created substrates should be adequately dried to ensure that the shrinkage process due to water-loss is completed before the wedi building board is fitted.
Step 1 Step 1 If necessary, prime the cement subsurface in advance and apply a perimeter isolation strip.
Step 2 Step 2 Apply tile adhesive to the substrate.
Step 3 Step 3 Apply wedi 610 adhesive sealant to the building board joints, if a sealing layer should be created in addition.
Step 4 Step 4 Embed the building board into the adhesive.
Step 5 Step 5 Affix a wide strip of wedi Tools self-adhesive reinforcement tape 600 mm with an overlap of approx. 5 cm. In wet areas, apply wedi Tools sealing tape to the building board to seal holes and joints.
Step 6 Step 6 Affix a wide strip of wedi Tools self-adhesive reinforcement tape 600 mm with an overlap of approx. 5 cm. In wet areas, apply wedi Tools sealing tape to the building board to seal holes and joints.

At a glance

Application guidelines wedi building board 0.00 MB) Teknisk datablad wedi byggeplade 0.15 MB Teknisk datablad wedi 610 0.17 MB

wedi system components

wedi building boards wedi 610 adhesive sealant wedi Tools joint reinforcement tape wedi Tools sealing tape
Persondataerklæring